Polysurfaces (red); extrusion objects (blue).
Extrudes use a base curve or surface to make an open or closed shape. Extrusions can be polysurfaces or lightweight extrusion objects.
Light-weight extrusion objects use only a profile curve and a length as input instead of the network of isocurves normally needed for NURBS objects. The Box, Cylinder, Tube, ExtrudeCrv, and ExtrudeSrf commands create extrusion objects. Extrusion objects can be closed with a planar cap or open. These objects will be converted to polysurfaces by some commands if necessary to add additional information for editing.
Lightweight extrusion objects use less memory, mesh faster, and save smaller than the traditional polysurfaces.
In models containing large numbers of extrusions represented by traditional polysurfaces, performance can be sluggish due to the relatively high demand on resources. If the same objects are made in Rhino as lightweight extrusion objects, these models are more responsive and more memory is available.
The UseExtrusions command controls the use of lightweight extrusion objects. To make commands that normally create extrusions create traditional polysurfaces, select the Polysurface option.
UseExtrusions
Specify whether extrusion objects or polysurfaces are used when extruding straight‑sided objects.
The UseExtrusions command controls the use of extrusion objects.
ConvertExtrusion
Convert extrusion objects to surfaces and polysurfaces.
SelExtrusion
Select Extrusion objects.
The SelExtrusion command will not select polysurface or surface objects. Use this command if you want to see which objects are extrusion objects.
Explode
Break objects down into components.
Exploding an extrusion object results in an exploded a polysurface.
Mesh
Create a mesh from a NURBS surface or polysurface.
The walls of extrusion objects are always meshed with quadrangles running the length of the extrusion. The caps are generally meshed with triangles.
SaveAs
Save the current model with a different name, close the current model, and open the new model.
Extrusion objects are converted to polysurfaces when saving as Rhino 4 or earlier.
ConvertExtrusion
Convert extrusion objects to surfaces and polysurfaces.
ExtrudeCrv
Drive closed planar curves in a straight line.
ExtrudeCrvAlongCrv
Drive closed planar curves along a path curve.
ExtrudeCrvTapered
Drive closed planar curves in a straight line tapering at an angle.
ExtrudeCrvToPoint
Drive closed planar curves tapering to a point.
ExtrudeSrf
Drive surface edges in a straight line to create a solid.
ExtrudeSrfAlongCrv
Drive surface edges along a path curve to create a solid.
ExtrudeSrfTapered
Drive surface edges in a straight line tapering at an angle to create a solid.
ExtrudeSrfToPoint
Drive surface edges tapering to a point to create a solid.
Box
Draw a solid box.
Cylinder
Draw a polysurface cylinder.
Pipe
Create a surface, polysurface, or extrusion object with a circular profile around a curve.
Slab
Offset a polyline, and extrude and cap the result to create a solid.
Boss
Extrude closed planar curves normal to the curve plane toward a boundary surface where the boundary surface is trimmed and joined to the extruded objects.
Fin
Extrude a curve on a surface in the surface normal direction.
Pipe
Create a surface, polysurface, or extrusion object with a circular profile around a curve.
Rib
Extrude a curve in two directions to a boundary surface.
Ribbon
Offset a curve and create a ruled surface between the curves.
Slab
Offset a polyline, and extrude and cap the result to create a solid.
Rhinoceros 6 © 2010-2020 Robert McNeel & Associates. 11-Nov-2020