VariableChamferSrf

Toolbar	Menu
Surface Tools	Surface Variable Fillet/Blend/Chamfer > Variable Chamfer Surfaces

Toolbar

Toolbar: Surface Tools

Surface

Variable Fillet/Blend/Chamfer >

Variable Chamfer Surfaces

History enabled. Click for more information. History enabled

The VariableChamferSrf command creates a chamfer surface between edges of intersecting surfaces with varying distance values, trims the original surfaces faces, and joins the resulting surfaces.

Steps

Select two intersecting surfaces for variable radius chamfer on the surfaces near the edge that will be chamfered.
Surfaces must intersect.
Handles will appear on surface edges.

Infinite Plane: Type IP for InfinitePlane options.

Press Enter to use the default distances.
Or
Type a new distance any time the ChamferDistance option displays on the command line.
Specify a command line option.
Or
Select a handle to edit.

Tips for using handle grips

The default handles have one grip that can be dragged to change the radius.
Any added or copied handles have two grips.
Use the grip on the edge to move the handle along the edge.
Use the grip in the center to change the radius at the handle location.

The Radius and Distance options appear on the command line when you drag a handle grip.

Radius/Distance options
FromCurve	Select a curve. The radius of the curve at the picked location will be used.
FromTwoPoints	Pick two points to show the radius distance.

Handle options
AddHandle	Adds a handle along the edges.
CopyHandle	Adds a new handle using the distance from the selected handle.
RemoveHandle	Visible only when at least one handle has been added.
SetAll	Sets the distance or radius for all handles.
LinkHandles	Editing a single handle updates all handles.

Note

Only added handles can be removed.
The default handles at the ends of each open edge segment cannot be moved or deleted. This is the minimum information the command needs in order to work.
The handle at the end of a single closed edge can be moved but not deleted.

RailType options
DistFromEdge	The distance from the edge curves determines the intersection.
RollingBall	The radius of a rolling ball determines the intersection.
DistBetweenRails	The distance between the edge rails determines the intersection.
TrimAndJoin	Trims and joins the resulting surface to the input surfaces. History only works if TrimAndJoin=No.
Preview	Displays a dynamic preview. You can change the options and the preview will update.

Tips

Always fillet from the largest radius to the smallest radius across a model.
Remove any edges you can prior to filleting with MergeAllFaces or by way of surfacing in a simpler manner. Fewer intersected edges = Fewer problems as the fillet rolls along any edges and tries to trim and join with the adjacent surfaces.
Make sure there is enough room for the fillet surface to trim and join with adjacent surfaces. The angle relationships between surfaces, sharpness of the bend in the rail around corners and rail type all play a part in any particular case.

VariableChamferSrf

Steps

Tips for using handle grips

Note

Tips

See also