Mesh
Polygon Mesh Primitives >
Truncated Cone
| Toolbar | Menu |
|---|---|
|
|
Mesh Polygon Mesh Primitives > Truncated Cone |
The MeshTruncatedCone command draws a mesh truncated cone.
Draw the base circle.
Pick a location or type a number to set the height.
The positive direction of the height is different based on the selected DirectionConstraint option.
Draw the end circle.
Base circle options
Direction constraints restrict the direction of the truncated cone.
Pick or type a number to set the height.
Creates a truncated cone perpendicular to the construction plane.
Draws the base circle perpendicular to the picked point on a curve. The center line of the truncated cone will be tangent to the curve.
Caps the top and bottom openings or leave them open.
Draws the base circle by picking the center point and a radius point.
Draws the base circle from two opposite points.
Draws the base circle through three points.
Draws the base circle tangent to one, two, or three curves.
Draws the base circle by fitting to selected points, control points, or mesh vertices.
The number of faces in the vertical direction.
The number of faces around the circumference.
End circle options
Pick a location or enter a number to set the end circle radius.
Pick a location or enter a number to set the end circle diameter.
TruncatedCone
Draw a NURBS truncated cone.
Rhinoceros 6 © 2010-2020 Robert McNeel & Associates. 11-Nov-2020