Solid
Cone
| Toolbar | Menu |
|---|---|
|
|
Solid Cone |
The Cone command creates a surface cone.
Command-line options
Direction constraints restrict the direction of the cone.
Pick or type a number to set the height.
Creates a cone perpendicular to the construction plane.
Draws the base circle perpendicular to the picked point on a curve. The center line of the cone will be tangent to the curve.
Decides if the bottom will be capped to create a solid or open cone.
Draws the base circle by picking the center point and a radius point.
Draws the base circle from two opposite points.
Draws the base circle through three points.
Draws the base circle tangent to one, two, or three curves.
Draws the base circle by fitting to selected points, control points, or mesh vertices.
MeshCone
Creates a mesh cone.
Rhinoceros 6 © 2010-2020 Robert McNeel & Associates. 11-Nov-2020