SoftEditCrv

Toolbar	Menu
Move Transform	Curve Curve Edit Tools > Soft Edit

Toolbar

Toolbar: Move | Transform

Curve

Curve Edit Tools >

Soft Edit

The SoftEditCrv command moves the curve area surrounding a selected point smoothly relative to the distance from selected point.

Note

Editing is done by moving the selected point. This location on the curve is moved, and the move is smoothly tapered off with increasing distance along the curve from this point.
Use this command to fine-tune curves with many control points.
The command takes over the moving of the control points so that the curve stays smooth. This is difficult on curves that are very dense. The falloff distance is adjustable, allowing the changes made to the curve to be more or less local.

Steps

Select a curve.
Pick a point on the curve.
Pick a point to move to.
Press Enter to end the command.

Note

The selection point snaps to the closest edit point.
Corresponding control points of the curve/surface are moved.

Command-line options
Distance	The distance, in model units, along the curve from the editing point over which the strength of the editing falls off smoothly. Either enter a value or click on the curve to set the distance.
Copy	Specifies whether or not the objects are copied. A plus sign appears at the cursor when copy mode is on. The RememberCopyOptions command determines whether the selected option is used as the default.
FixEnds	Determines whether or not the position of the curve ends is fixed. No If the Distance value is larger than the distance to one or both ends of the curve, the end of the curve will be allowed to move. Yes If the Distance value is larger than the distance to one or both ends of the curve, the end of the curve will not be allowed to move. With the Yes option, all control points are moved as they would be according to the normal falloff except the end control points. This can lead to an abrupt change in the curve near the end on dense curves.

Command-line options

Distance

The distance, in model units, along the curve from the editing point over which the strength of the editing falls off smoothly.

Either enter a value or click on the curve to set the distance.

Copy

Specifies whether or not the objects are copied. A plus sign appears at the cursor when copy mode is on. The RememberCopyOptions command determines whether the selected option is used as the default.

FixEnds

Determines whether or not the position of the curve ends is fixed.

No

If the Distance value is larger than the distance to one or both ends of the curve, the end of the curve will be allowed to move.

Yes

If the Distance value is larger than the distance to one or both ends of the curve, the end of the curve will not be allowed to move.

With the Yes option, all control points are moved as they would be according to the normal falloff except the end control points. This can lead to an abrupt change in the curve near the end on dense curves.

SoftEditCrv

Note

Steps

Note

No

Yes

See also